 |
Driveway Alarm Custom Accessories |
Sirens, bells, light control, counters, more for your driveway alarm.
|
These Accessories Work With:
|
Indoor/Outdoor Fire Alarm Bell |
 | |
The Firebell Indoor/Outdoor bells utilize a specially designed gong that gives out a loud mechanical resonant tone. Designed for more effectiveness and will provide better performance and dependability at a lower current consumption than previous models. The bell design incorporates a micro-motor with built-in varistor suppression element to reduce RFI and EMI interference found in today's highly integrated microprocessor driven control panels. Then terminal design makes it convenient when wiring or troubleshooting. The design features as a result saves you time and provides a more effective installation for maximum performance.
- Indoor/Outdoor motor driven design
- UL Listed for fire protective service
- Polarized models with wide listed voltage range using filtered DC or unfiltered FWR input voltage.
- Terminals for fast in/out field wiring.
- High sound dB output with low current draw.
- Built-in trim plate for a clean flush mount installation.
- Input terminals for field wiring using AWG 12 to 18.
- RFI and EMI noise suppression element built-in.
- Red color.
- 6 Inch Bell.
|
- Know how many entered or left your driveway.
- Plugs into the side of the receiver.
|
- This unit can turn on lights & ring remote door bells
- Plugs into the side of the receiver and then into a 110V AC plug and transmits a signal through your house wiring to activate the Remote Chime or the Lamp Module.
|
- Will work anywhere in your home.
- Requires X10 Interface module above.
|
- Just plug in your lamp It will turn on a lamp when the driveway alarm is tripped.
- Requires X10 Interface module above.
|
|
Two-Tone Ding Dong Doorbell |
- Plugs into the side of your Driveway Alarm receiver.
|
- Extra loud and you may use out doors
- Wires into the receiver
|
- A bright, 12 volt, flashing strobe.
- Really gets your attention.
- Ideal for the hearing impaired.
- Comes with a 10 foot cable and quickly connects to the
- Driveway Alarm System INFRS-1 receiver.
- Requires receiver with timing circuit.
|
- Plugs into the side of the receiver.
- Produces a buzzing sound.
|
- This option allows for the use of multiple power sources.
- A quick release system provides for a 110 volt source, 12 volt source and 9 volt source.
- Ideal for campers and situations where 110 volt is not available.
- This option must be factory installed.
|
|
 |
